1-1/2" Wide Window Felt or Run Channel
Steele Rubber Products has the best quality flexible Window Felt or Glass Run Channel material for your Street Rod or Custom Build project. This part helps to eliminate window rattle, provides a smooth sliding surface for glass movement and works to protect the glass.
Black Door Lock Knob
p/n: 30-0251-71
Knob, inside door lock control, flexible rubber, black only.Height: 1.125 inches.
Body Hole Plug
p/n: 20-1040-21
This Body Hole Plug is designed from the original part for superior fitment, finish and function. This plug is made from high quality EPDM dense rubber to provide excellent durability. This body plug covers a sheet metal hole that is one and one half (1-1/2") inch in diameter.
Brown Door Lock Knob
p/n: 70-0354-70
This is the knob or button for the inside door lock control rod. Neutral brown color rubber, 3/32 inch hole. The part fits many different vehicles.
Brown Door Lock Knob
p/n: 70-0660-70
This is the Knob or push button for the inside door lock. The part fits over 1/8" steel rod to door lock. Neutral brown color that may be lacquered with other colors as required. A hard rubber part fits many different vehicles.
Cap Seal
p/n: 70-3437-73
Seal, cap on body of door. Located at the striker on door top for right and left sides. Fully molded rubber with two (2) screw holes.
Chrome Molding Washer
p/n: 60-0727-45
Washer, for attaching chrome moldings on body. Fits into metal cup retainer. Three fourths (3/4) inch diameter, use as required.
Coupe Hinge Pillar Weatherstrips
p/n: 70-3934-63
This Coupe Hinge Pillar Weatherstrip attaches to the body and seals between the A-pillar post and the front section of the door or vent window frame when the door is closed.
Dash to Door Windlace Weatherstrips
p/n: 70-3951-72
This Dash To Door Windlace Weatherstrip is a pair of manufactured weatherstrip seals, one for each door, that are designed from originals and made for a like factory fit.
Dash to Door Windlace Weatherstrips
p/n: 70-3952-72
This Dash to Door Windlace Weatherstrip is a pair of manufactured weatherstrip seals, one for each door that are designed from originals and made for a like factory fit.
Division bar grommet
p/n: 70-3135-62
Grommet, rear door vent divider post. Upper and lower, right and left. 4 piece set.
Door Bottom Drain Hole Seal
p/n: 70-0938-70
This Door Bottom Drain Hole Seal is designed from the original part for superior fitment and seal. This part fits into the lower door on both two (2) and four (4) door models.
Door Bumper
p/n: 40-0235-70
Bumper, door striker plate. Two (2) per door, front and rear.Length: 1.375 inches. Width: .50 inches.
Door Bumper
p/n: 70-2045-71
This Door to Body Bumper is quality reproduction of the original factory part. Use varies depending upon model and body type. Some models uses four (4) bumpers for front doors and four (4) for rear doors.
Door Check Arm Bumper
p/n: 20-1639-70
This Door Check Arm Bumper is designed from the original part for superior fitment and function. This rubber with arm slot bumper mounts on the door check arm. Works to cushion the door swing.
Door Check Link Rod End Stop
p/n: 70-0479-70
End nut, check link (rubber bar with steel bar insert). Three fourths (3/4) inch by three fourths (3/4) inch by two (2) inch threaded five sixteenths (5/16) inch. (For round stop nut, see our #70-0326-70).
Door Check Link Rod End Stop
p/n: 70-0325-70
A quality Door Check Link Rod End Stop for rod type door check mechanism. One (1") inch diameter by three-eighths (3/8") inch thick with five-sixteenths (5/16") inch hole.
Door Check Link Rod End Stop
p/n: 20-1640-70
This Door Check Link Rod End Stop is designed from the original part for superior fit and function. This door stop fits between the door and body to limit the swing opening of the door preventing overtravel. Door check arm and bumper. Enough for one door.
Door Check Link Rod End Stop
p/n: 70-0326-70
End stop and pad, door check link rod. Rubber with embedded steel plate, five sixteenths (5/16) inch diameter thread. Most models with rod type door checks.
Door Check Link Rod End Stop Washer
p/n: 70-0384-70
A quality Door Check Link Rod End Stop Washer for door check mechanism. One and seven-sixteenths (1-7/16") inch diameter by three-sixteenths (3/16") inch thick.
Door Check Strap
p/n: 40-0535-70
Strap, door check. T-type, special heavy duty construction of rubber with multiple ply webbing and molded-in steel crossbar. Full length as original with one eighth (1/8) inch by seven eighths (7/8) inch steel crossbar.
Door Check Strap
p/n: 40-0536-70
Strap, door check. T-type, special heavy duty construction of rubber with multiple ply webbing, molded-in steel shank and molded-in steel crossbar. Full length as original with one eighth (1/8) inch by seven eighths (7/8) inch steel crossbar.
Door Check Strap
p/n: 20-2106-70
This Door Check Strap is designed from the original part for superior fitment and seal. This check strip fits between the body post and door.
Door Check Strap Bracket - Adjustable
p/n: 70-4549-70
This adjustable Door Check Strap Bracket is designed from the original part for superior fitment and function. This bracket works with our Door Check Strap #20-2106-70 requiring one bracket per strap.
Door Check Straps - Black
p/n: 10-0145-70
Door Check Straps - loop type. Made from top quality Black rubber to ensure durability. This part is compatible with models built by Independent (1920 - 1932) automobile manufacturers.
Door Check Straps - Brown
p/n: 10-0145-89
Door Check Straps - loop type. Made from top quality Brown rubber to ensure durability. This part is compatible with models built by Independent (1920 - 1932) automobile manufacturers.
Door Conduit
p/n: 70-0828-21
Conduit, hydraulic line & power window wire. Front doors only. 2 pieces cut nine and one half (9-1/2) inches.Length: 9.50 inches. Height: 1.50 inches.
Door Conduit Set - Wiring - Vacuum Hoses
p/n: 60-0655-21
A six (6) piece Door Conduit set for the front door electric window wires or power lock vacuum lines. The set includes two (2) hoses and two (2) pairs of grommets.
Door Conduit Set for Power Windows
p/n: 60-0653-21
This Door Conduit Set is designed from the original part for superior fitment and function. Conduit contains the front door electric window wires and/or power lock vacuum lines. Set includes two (2) hoses and three (3) pair of grommets. Length: 12.0 inches.
Door Drain Hole Seal
p/n: 70-1042-70
Weatherstrip, door bottom drain hole.Length: 3.625 inches. Width: .40625 inches.
Door drain hole seal
p/n: 70-3034-70
Seal, door inner panel drain. Attaches to bottom of door with one (1) carrot retainer on either end.
Door Drain Hole Seal
p/n: 60-0442-70
This Door Drain Hole Seal installs on the door bottom and is also used on the tailgate of station wagons. Two (2) required per vehicle. Molded from high-quality EPDM dense rubber.
Door Filler Caps
p/n: 70-4637-70
This convertible model Door Filler Cap pair is designed from the original part for an authentic fit, finish, and function. These door fillers cap the top of the half-post between the front and rear doors on convertible models.
Door Hinge Seals
p/n: 70-1460-70
This Door Hinge Seal installs on the front door hinge pillar at the beltline. These seals are sold as a pair for the left and right side.
Door Jamb Wire Loom Grommets
p/n: 70-4870-70
These Door Jamb Wire Loom Grommets go between the door and door jam and allow you to run wires or cables through them. They make great complements to power window kits, shaved door kits, or custom stereo installs.
Door Lock Striker Revulcanization Service
p/n: 30-0398-71
This Revulcanization Service Only is to restore your front or rear Door Lock Striker to it's like new original condition. Service requires your old metal striker core. Please call or email for more service details and ordering.
Door Plug Beltline Extender
p/n: 70-3214-62
This Door Plug Beltline Extender pair is designed from the original part for superior fitment and seal. This piece works on beltline as an extender. Width: 2.0 inches.
Door to Body Conduit, Power Window Wiring
p/n: 70-1538-70
This Door to Body Conduit set is designed from the original part for superior fitment and function. This is the sheathing conduit for the power windows wiring from the front door to the body through the hinge pillar.
Door Vent Window Foot
p/n: 20-2556-62
This Door Vent Window Foot installs at the base of the front door vent window frame. Sold as a pair.
Door Weatherstrip
p/n: 14-0020-70
Weatherstrip, door "plateau", to seal and shunt water to drain. Made with metal core and correct mounting holes.Length: 10.0 inches.
Door Weatherstrip
p/n: 70-1650-70
Seal, rear door at rear of window.Length: 1.75 inches. Width: .875 inches.
Door Weatherstrip End Caps
p/n: 70-4659-73
This Door Weatherstrip End Cap pair is designed from the original part for superior fitment and seal. Left and Right End Caps mount on the end of the door weatherstripping, near the quarter windows on convertible models.
Door Weatherstrip Fastener
p/n: 50-0198-73
This Door Weatherstrip Fastener is steel with a black finish. Each push-in fastener measures one half (1/2") inch long with a thirteen thirty second (13/32") inch diameter head. Reproduction fastener is designed from the original part to fit correctly.
Front Body Upper Pillar Drain Trough
p/n: 70-4212-73
This Front Body Upper Pillar Drain Trough pair is designed from the original part for superior fitment and seal. This left (LH) and right (RH) drain trough pair fits above the front upper door hinge, one per side.
Front Door Inner Dog Leg Weatherstrips
p/n: 20-1767-70
This Front Door Inner Dog Leg Weatherstrip pair is designed from the original part for superior fitment and seal. This rubber weatherstrip installs on inner dog leg of the front door.
Front of Door To Window Seals
p/n: 70-4765-79
This Front Of Door to Window Seal pair is designed from the original part for superior fitment and seal. This is the door seal that mounts at the front of the door and seals where the door glass comes through.
Front Of Door To Window Seals
p/n: 20-2838-79
This Front Of Door to Window Seal pair is designed from the original part for superior fitment and seal. This is the door seal that mounts at the front of the door and seals where the door glass comes through.
Front of Vent Window to Door Seals
p/n: 20-2786-62
These Front of Vent Window to Door Seals are installed at the front of the door and next to the door weatherstrip. Sold as a pair.
Hinge Pillar and A-Post Weatherstrips
p/n: 82-0156-64
This Convertible Hinge Pillar and A-Post Weatherstrip pair is designed from the original part for superior fitment and sealing. This weatherstrip pair attaches to the windshield frame upper A-pillars and seal between the A-pillar post and the front section of the door or vent window frame when the door is closed.
Hinge seal
p/n: 70-0481-73
Filler, front door hinge pillar at dash, right and left. With metal core. Located at top front of front door, under door flange.
Inside Door Handle Gaskets
p/n: 70-4811-69
This Inside Door Handle Gasket pair is designed from the original part for an authentic fit, finish, and appearance. Slips onto edge of hole where door handle comes out of the door panel.
Lower Door Weatherstrip Retainers
p/n: 20-0393-73
This Lower Door Weatherstrip Retainer pair is designed from the original part for superior fitment, finish and function. A pair of retainers for the lower door weatherstrips that mount on the left and right rocker sills. Does not include door weatherstrips.
Lower U-Jamb Lock Pillar Rear Seals
p/n: 70-3954-79
This Lower U-Jamb Lock Pillar Rear Seals pair, one for each door, is designed from originals and made for a like factory fit.
Rear Cargo Door Hinge Gaskets Set
p/n: 60-0659-69
This four (4) piece molded Rear Cargo Door Hinge Gasket Set is made to original specifications for proper fitment. Seals are fully molded from top quality rubber to ensure durability, fitment and proper seal.
Rear Door Hinge Pillar Weatherstrip
p/n: 70-1655-70
Weatherstrip, rear door hinge pillar.Length: 2.75 inches.
Rear Door Window Upper Seal
p/n: 70-4198-79
This Rear Door Window Upper Seal pair is designed from the original part for superior fitment and sealing. This rectangular shaped seal pair mounts to the rear door at the upper front and over the rear side window.
